Conel UCR11 v2 Betriebsanweisung

CDMA/UMTS router UCR11 v2 and UCR11 v2 SLUSER’S GUIDE

ROUTER DESCRIPTION5. Router design5.1. VersionBox SIM1 SIM2 I/O USB PORT1 PORT2 ETHUCR11 v2B set PlasticUCR11 v2B SL set MetalUCR11 v2F set PlasticU

ROUTER DESCRIPTION5.3. Ordering code5.3.1. Basic versionExpansion port Ordering codeVersion without expansion port UCR11 v2B setVersion with expans

ROUTER DESCRIPTION5.4. Basic dimensions plastic boxFig. 7: Basic dimensions plastic box5.5. Basic dimensions metal boxFig. 8: Basic dimensions metal

ROUTER DESCRIPTION5.6. Mechanical external dimensions and mounting recommendationsMounting recommendations:• possibility to be put on a work surf

ROUTER DESCRIPTIONfor every cables we recommend to bind the bunch according to the following picture, we recommend for this use: length of the bunc

ROUTER DESCRIPTION5.7. User interfaces (connectors) On the front panel is located:Label Connector DescriptionPWR 2-pin Connector for connection the

ROUTER DESCRIPTION5.7.1. Status indicationAbout router status inform eight led indicators on the front panel and on every port are two LED indicator

ROUTER DESCRIPTION5.7.2. Power connector PWRPanel socket 2-pin.Pin numberSignal markDescription1 VCC (+) Positive pole of DC supply voltage (+10 to

ROUTER DESCRIPTION5.7.3. Antenna connector CDMA, UMTS and AUX All of these antennas are connected to the router using the SMA connectors on the fron

ROUTER DESCRIPTION5.7.4. SIM card readerThe SIM card reader for 3 V and 1.8 V cards is located on the front panel of the router. To initiate the

USED SYMBOLSUsed symbolsDanger – important notice, which may have an influence on the user’s safety or the function of the device.Attention – notice o

ROUTER DESCRIPTION Ethernet cable plug into the RJ45 connector labeled as ETH (see figure bellow).Fig. 24: Connection Ethernet cableThe ETH router c

ROUTER DESCRIPTION5.7.6. PORT1The PORT1 is equipped with one of the offered options ports. For PORT1 are available on the interfac

ROUTER DESCRIPTION5.7.8. USB port Panel socket USB-A.Pin numberSignal mark Description Data flow direction1 +5V Positive pole of 5V DC supply voltag

ROUTER DESCRIPTION5.7.9. I/O portPanel socket 3pin.Pin no.Signal markDescription Data flow direction1 BIN0 Binary input Input2 GND Signal ground3 OU

ROUTER DESCRIPTION5.7.10. ResetIt is important to distinguish between reset and reboot the router.Action Router behavior Invoking eventsReboot Turn

ROUTER DESCRIPTION6. First use6.1. Connecting the router before first useBefore you give up the router, it is necessary to connect all

ROUTER DESCRIPTION6.2. Start routerThe router is set up connecting the power supply to the router. In the default setting the router starts to

TECHNICAL PARAMETERS7. Technical parameters7.1. Technical parameters of routerUCR11 v2Complies with standardsEN 301 511, v9.0.2,EN 301 908-1&2,

TECHNICAL PARAMETERS7.3. Technical parameters of CDMA moduleCDMA moduleCDMA parametersData rate 3,1 Mbps/1,8 MbpsCDMA2000 1x EV-DO Rev.ABackward compa

RECOMMENDED LITERATURE8. Recommended literature[1] Conel: Start guide,[2] Conel: Configuration manual,[3] Conel: User’s manual – Expansion port RS23

CONTENTSContents1.Safety instruction 12.Product disposal instructions 23.Router description 34.Contents of package 45.Router design 55.1.Version 55.2.

FAQ10. FAQ I can’t get from internet on equipment, which is connected to router and I have NAT enabled.  The device's gateway has to be confi

FAQ RS232 doesn’t function. It is necessary to verify present the expansion port RS232.  Verify present the expansion port RS232 in

CUSTOMERS SUPPORT11. Customers supportUp to date information about the product is on website:http://www.conel.cz/Upkeep-advices: The SIM-card must be

IMAGE LISTImage listFig. 1: Contents of package 4Fig. 2: Front panel UCR11 v2B 5Fig. 3: Front panel UCR11 v2F 5Fig. 4: Front panel UCR11 v2B SL 5F

TABLE LISTTable listTable 1: Expansion port possibilities 4Table 2: Router version 5Table 3: Delivery identification 5Table 4: Ordering code of basic

SAFETY INSTRUCTION1. Safety instructionPlease, observe the following instructions:• The router must be used in compliance with all applicable internat

PRODUCT DISPOSAL INSTRUCTIONS2. Product disposal instructionsThe WEEE (Waste Electrical and Electronic Equipment: 2002/96/EC) directive has been in

ROUTER DESCRIPTION3. Router descriptionRouter UCR11 v2 use two modules UMTS/HSDPA and CDMA for wirelessly connect various equipments and devices vi

ROUTER DESCRIPTION4. Contents of packageBasic delivered set of router includes:• router,• power supply,• crossover UTP cable,• UMTS external ant